FabricIQ
Reading the label…
01Verdict
Safe to wear, but rough on the environment.
Best for Safe to wear; production isn't clean — donate when done.
Material C · 62Health A · 100Eco · 53Label · high
Why this material grade?
This product scored 62/100 on the material-quality rubric (durability, comfort, breathability, warmth, moisture-wicking, care-ease), based on its composition of 65% Viscose, 35% Linen. Sustainability is scored separately as the Eco Rating. Blended from 65% Rayon, 35% Linen — the score is a weighted average based on each material's proportion.
C (55-69): Average material composition — typical blend, reasonable for everyday wear.
Everyday quality
This fabric does the job for daily wear. Not premium, not bad — it's the middle of the road. Follow care instructions carefully to extend its life.
Overpriced for the fabric
$155Below-typical fabric quality at an above-median price — you may be paying for the label, not the material.
$2.50 per quality point Category median: $97 · grade C
Fabric value only — compares material quality to price vs other shirts. Construction, fit, and brand aren't measured.
02Breakdown
Composition
65% Viscose, 35% Linen
All-natural fiber
Added Jun 12, 2026 · Data last updated Jun 12, 2026
Sustainability is scored separately — see the Eco Rating below.
🏛️
Linen is made from flax, which grows in poor soil with little water. It's been used for clothing for over 30,000 years.
⚖️
Linen (score 76) is carrying this blend. Rayon (score 54) is pulling it down.
03Network
Cost per wear
rough estimate$2.21/wear · 70 expected wears
Investment piece — wear it
How we got there
Base for Shirts: 100 expected wears.
× 0.70 for Rayon (low-durability fiber, durability 51).
= 70 expected wears. $155 ÷ 70 ≈ $2.21/wear.
Missing GSM — this is a category-level estimate, not garment-specific. Expect ±30% variance.
Real life is messier than a formula: how often you wash, how you wash, whether you wear it inside-out, dry on low — all of it shifts the number. This is the ceiling under reasonable care.
Care Guide
Decode symbolsWash
cold (30°C)
Bleach
Do not bleach
Dry
line dry
Iron
Best For
🏃Athletic Wear
GoodGood breathability (80) and moisture wicking (52) for light activity
😴Sleepwear
GoodGood comfort (76) and breathability (80) for sleeping
🩲Underwear
GoodGood breathability (80) and comfort (76) for undergarments
Better Alternatives
Higher-rated shirts products — each card shows how much better this alt scores vs your current product.
04Tradeoffs
Health Impact
Microplastic shedding · skin-contact synthetic load · likely chemical treatments
A100/100
Low health impact — predominantly natural fibers with no major treatment flags.
Microplastics LOW
Minimal
Skin contact LOW
0% synthetic
Chemicals LOW
No flags
What this score doesn't measure
- ×Fiber grade. Staple length, micronaire, strength. "100% cotton" could be short-staple upland or long-staple Pima — same label, very different fabric.
- ×Yarn processing. Singles count, ply (single vs two-ply), spinning method (open-end vs ring-spun vs compact), mercerization. Invisible from any label.
- ×Knit / weave structure. Single jersey vs interlock, knit tightness. A loose knit pills; a tight knit lasts.
- ×Fabric weight (GSM). One construction signal among several — and high GSM can come from loose cheap yarn just as easily as from fine tight yarn. We have it for blank manufacturers, rarely for retail.
- ×Pre-shrink processing. Sanforized cotton shrinks ~1%; non-sanforized can shrink up to 10%. Not visible from the composition tag.
- ×Construction quality. Stitch density (SPI), seam types, collar geometry, manufacturing tolerances (AQL). These often matter more than the fiber itself.
- ×Specific chemical loads. Health Impact flags "likely PFAS / possible formaldehyde" from composition × category — we don't lab-test individual SKUs.
We rate the fabric, not the garment. Composition is the floor of what you're guaranteed to be getting — most shoppers don't have that.
05Action
